Edge appliance configuration and modules

Each appliance has a numbered configuration, signed by the service and applied by the appliance at its next sync. Changing the configuration is a policy change: it is approved on your phone or with your passkey.

How do I change the configuration?

1. Under «Operate» › «Edge appliances», choose «Configuration» on the appliance. «Appliance configuration» opens.
2. Adjust:

3. Choose «Save configuration» and approve. The phone shows «Change the configuration of an Edge appliance», with the appliance, the revision replaced and the command digest.
4. The console shows «Revision 4, applied 3» until the appliance applies the new revision.

If you do not approve: «Nothing was saved: the change was not approved.» With no saved configuration, the appliance runs its defaults.

Which modules are there?

The console offers only the modules the appliance agent runs, so today the configuration shows only «Privileged access». A module saved earlier that the agent does not run stays in the configuration, hidden, and saving does not switch it off. A new module appears in the dialog once the appliance supports it.

Disable and enable

«Disable» stops the appliance working without retiring it; «Enable» allows it again. A disabled appliance only receives that instruction at its sync.

Errors

«Someone else changed this configuration. Reopen it.» and «Check the interval (15 to 300 seconds) and the networks (at most 16 CIDRs).»